Ø 10.00 – 38.00 MM COLD SAW

Installed Power                                 : 20 Kw

Saw rotation motor                         : 6.7 kw x 2000 rpm

saw car forward-backward mot. : 11 kw x 3000 rpm – Servo Motor

Max line speed                                  : 160 meter /min (It is valid for 8 meters tube length)

Tube thickness                                  : Min 0.30 – Max 2.50 mm

Round pipe                                         : Ø 10.00 – 38.00 mm (Can cut all tubes in range)

Square profile                                    : 10x10 – 30x30 mm (Can cut all tubes in range)

Rectangular profile                          : 10x20 – 20x40 mm (Can cut all tubes in range)

Tube material (Max Tensile)        : Ts=360 N/mm2

Tube material (Max Yield)            : Fy=310 N/mm2

Tube material                                     : Cold&Hot Rolled - pre Galvanized

Clamp vovement                              : Hydraulic

Saw Type                                             : TCT – HSS

SAW OD                                               : Min 300 mm – Max 450 mm

Saw rotation speed                         : 240 meter/min

Direction                                              : Right to Lef tor Left to Right

Max length error                              : ± 1.00 mm

Length to cut                                      : 4-12 meter

Input voltage                                      : 380 V /50 hz / 3 Ph.

Control voltage                                 : 110 V                 

Car Drive System                              : Timing Belt

Saw Advance                                     : Ball Screw with beraing

Mechanical Safety System           : Hydraulic Shock Absorber

Slide Lubrication System               : Automatic multi-point grease

Cutting Cooling                                 : Boron oil fed from the pipe mill

ELECTRICAL AND ELECTRONIC SYSTEMS

Drive: ControlTecniques

PLC: industrial PC CodeSys

HMI: Jmobile PC Runtime

IO: Crevis input output

Communication protocol: EtherCAT

Servo: Nidec+HPB motor

Switching equipment: ABB, Schneider Eelectirc, Omron, Siemens

Complate units of electrical and electronic systems required for the machine, will be supplied.

Automation, power cabinet pulpit desks.

Starting from the low level the automation system of the plant is composed by:

• Motors

• Motor Drives (in this case inverters);

• Plant sensors and actuators;

• PLC

Man-Machine interface :

Mill control desk with display interface; controls saw cutting

Main control system;  PLC control by Control Techniques Driver