Weight Capacity: 20,000lbs
Width: 20"

20,000lbs Mandrel Uncoiler, Mandrel Face : 20", ID: 16" to 20", Coil OD: 66", Peeler Table, Recoiler, Allen Bradley Micrologic PLC, Operator Push Button Panel, Hydraulic Unit

Serial No. 9106601

20" Dia Drum
78" Drum Face
Hydraulic Expansion and Gripper
Hydraulic Push-off
Overarm Separator
200HP DC Motor (650/ 2200RPM)  500 Volt
Horburgh & Scott gearbox (30.37:1)
Bolt on Risers for 24" I.D.

New Control Techniques DC Drive
Model Number Quantum lll
Sysmac PLC Model C200HS

Line Direction:  Right to Left

Braner/Nuttall Gear Design, Drum Face: 68", Ratio: 9.396, Service Factor: 1.0, Output RPM: 53/213, Condition: New Never Used

Coil Capacity:  40,000lbs
Coil ID: 16 - 24"
Coil OD: 72"

62" Mandrel Face, 4 Leaf Hydraulic Expansion, Slidding Base, Hold Down Roll, Air Clutch, Air Actuated Disc Brake, 10 HP AC Feed Up Drive, Rowe 40,000lbs Coil Car, 
Floor Standing, Motorized : Up/Down, In/Out, Puch Button Controls

Capacity: 30,000Lbs(13 MT), Drum Face:  66"(1676mm), I.D.:  20"(508mm), Hydraulic collapse and push-off, Gear box ratio:  9.159:1, New bearings:  1997, Direction: Right to left

60" Mandrel Face, 16" Coil ID, 72" Coil OD, 50 HP DC Drag Generator Brake, 400 - 1200 RPM, 3 Speed Drive All Gear Box, Hydraulic Sliding Base, Outboard Bearing Support, 4 Leaf Hydraulic Expansion, 57" Mandrel Center Line.

Line Speed: 2000 FPM, Material Thickness: .229" - .010", 20" Coil I.D., 78" Coil O.D., 1.85:1 Main Gear BU8 Ratio, 2-1085 H.P. DC Motors, 650 Volt, In Tandem, Outboard Bearing Support, Entry & Exit Coil Cars, Numerous Spare Parts.

Make: Dahlstrom, Model: 16H-18-1824, Weight: 20,000Lbs, Mandrel Width: 52", Hydraulic Expansion, 4-Leaf Mandrel, Sliding Base, Feed-Up Drive, Air Clutch

Uncoiler Manufacturer: EGAN Machinery Inc., Serial# 1501-24, Model: 3635, Weight Capacity: 20,000lbs, Mandrel face: 32", Coil ID: 20"-24", Vickers Hydraulic Mandrel Expansion, Hydraulic Cooled Brake, V-Type Coil Car, Coil Width: 55", Coil Weight: 20,000lbs

Mandrel Face: 27" (686mm), Weight Capacity: 15,000 Lbs. (6.8 Tons), Coil ID Range: 20" (508mm) Diameter (Pads for 24" (610mm)), Hydraulic Sliding Base, Hydraulic Expansion, Wichita Water Cooled Brake, Four Leaf Mandrel, Feed - Up Drive, Hydraulic Sliding Base, Line Direction Right to Left